Siemens SINUMERIK Commissioning Manual page 13

Introduction
1.1 State of the system when supplied
Overview
This manual describes the commissioning of the HMI-Advanced software. When
commissioning the SINUMERIK control, you may require additional manuals:
● Operator Components and Networking
● Commissioning Manual PCU Basic Software
● Diagnostics Manual
● Parameter Manual
● Function Manual Basic Functions
Software
Depending on the order details, the HMI-Advanced software may be loaded on the PCU 50.3
at the time of delivery. If the HMI-Advanced software is not installed on the PCU 50.3 (e.g.
PCU 50.3 is supplied without system software), the HMI software can be installed on the
PCU 50.3 from the CD through Service Center.
To install the HMI-Advanced software on the PCU 50.3, you need the following:
● PC or PG with CD drive
● Network connection
● USB memory
The HMI Advanced software can run on the Windows XP SP2 operating system.
NOTICE
Installing on a PC/PG:
HMI-Advanced can then only be run under a non-administrator user, if this user has write
authorization for directory mmc2 of HMI-Advanced. The installation of HMI-Advanced does
not provide this authorization.
HMI Advanced (IM4)
Commissioning Manual, 03/2009, 6FC5397-0DP10-3BA0
Additional information on special NCK, HMI, PLC or drive functions are provided in the
Function Manuals.
1
7