Siemens SINUMERIK Commissioning Manual page 236

Tool management
6.2 Settings in the configuration file
Entries in the paramtm.ini file
[GeneralSettingsForMagAndToolList]
;In magazine list forms change softkey "Next Mag"
; to softkey "Magazine Selection", to activate vertical softkeys
; in an additional state for magazine selection.
; This helps to prevent users from excessive use of
; "next mag" softkey if a lot of magazines are available.
; You can define shortcut softkeys for up to 5 favorite
; magazines per TOA using section [ShortcutSoftKeysForMagSelect]
; in paramtm.ini and patm_??.ini.
MagListMagSelectSoftkey=NextMag ;default
;MagListMagSelectSoftkey=SelectMag
[ShortcutSoftKeysForMagSelect]
; Definition of shortcut softkeys for up to 5 favorite magazines
; per TOA, evaluated if section "[GeneralSettingsForMagAndToolList]"
; entry "MagListMagSelectSoftkey=SelectMag" is set.
; This helps to prevent users from excessive use of "magazine +" and
; "magazine -" softkeys, if a lot of magazines are available.
; You can define up to 5 shortcut softkeys for favorite magazines.
; It is possible to use a shortcut softkey for different magazines,
; if the magazines are in different TOAs.
; Syntax: "magIdent = ShortKeyNumber, AutoReturn"
; Examples: turret15=3,NoAuto<<
; chain50 =1,Auto<<
; Explanation: "magIdent": magazine ident like in $TC_MAP2 or
; in magazine configuration in application maintenance
; tool management. "ShortKeyNumber": Number of shortcut,
; value 1 to 5 "AutoReturn":
; stay in magazine selection state or return automatically
; to magazine list state Values "NoAuto<<" and "Auto<<".
; magazine "turret15" ($TC_MAP2) can be displayed
; by shortcut 3, you must use "<<" softkey explicitly to leave
; magazine select state.
; magazine "chain50" can be displayed by shortcut 1 and
; there is an automatic return to magazine list state
; after pressing this shortcut softkey.
; To specify softkey text, use section
"[ShortcutSoftKeysForMagSelect]" in language dependent ini files
; patm_??.ini.
chain10 = 1, Auto<<
; turret20 = 2, Auto<<
> ;turret10 = 3, Auto<<
> ;chain20 = 5, NoAuto<<
> ;turret15 = 4, NoAuto<<
230
Commissioning Manual, 03/2009, 6FC5397-0DP10-3BA0
HMI Advanced (IM4)