Siemens SINUMERIK Commissioning Manual page 686

Configuring the system
2.4 PCU 50.3 with SITOP UPS module
2.4 PCU 50.3 with SITOP UPS module
Conditions
● PCU-Basesoftware WinXP V08.00.00 or higher for USB port
● HMI Advanced of V07.01.00 or higher
● SITOP software, version 2.5.2.4or higher is installed:
● SITOP monitor/configuration program is installed:
● UPS USB driver for Windows XP is installed:
● The SITOP UPS hardware is connected.
Application
If the supply voltage at the PCU dips, the SITOP UPS modules below could maintain
operation for a limited period if a backup battery is being used, allowing the PCU to be
properly shut down before the battery is exhausted:
Name
SITOP POWER DC UPS module 15 (USB interface)
Note
Information about the test environment for machine OEMs
The "SITOP UPS" function has been tested in the standard configuration of HMI Advanced.
When installing add-on or OEM software components, the shutdown procedure of the
complete system has to be checked by the operator.
46
SITOP software is available to download from: www.automation.siemens.com/sitop.
To enable this, the SITOP software must be copied to the E:\SITOP directory set up on
the PCU. This directory already contains PCU tools required for shutdown on the SITOP
UPS. If this directory does not exist in an older version of the PCU-Basesoftware, it must
be created so that it will be compatible for any subsequent updating of the PCU-
Basesoftware.
Installation is described in the relevant SITOP documentation. The documentation is part
of the SITOP software download package.
NOTICE
The SITOP software version 3.1.0.6 can be operated with PCU-Basesoftware
V08.02.00.01 or higher subject to the following conditions:
• SITOP software must not be installed as a Windows service, but must be started as
a normal application (as described in the chapter titled "Starting and configuring the
SITOP monitor").
• The SITOP service prevents the correct switch-off procedure being performed on the
SITOP UPS module when PCU-Basesoftware is installed.
Order number (MLFB)
Commissioning Manual, 03/2009, 6FC5397-1DP10-4BA0
6EP1931-2EC41
PCU-Basesoftware (IM8)