Siemens SINUMERIK Commissioning Manual page 697

3.3 How to install and authorize SIMATIC STEP 7
Overview
SIMATIC STEP 7 V5.4 SP1 can also be installed on the PCU.
Delivery item:
Components:
Type of delivery:
System requirements:
Note
The "MPI driver" package available on the PCU is part of the HMI software and must not be
uninstalled!
Installation under Windows XP
You must follow the installation sequence described here!
1. Boot up the PCU in the service desktop.
2. Access DVD (via network or external DVD drive) and call up SETUP.EXE in the root
3. The installation proceeds with operator prompting. The installation directory for STEP 7
4. The prompt for "Transfer license keys" must be answered with "No, transfer the license
5. Switch to the Sinumerik_Add_on directory on the DVD and call SETUP.EXE. The
6. Start the link "STEP7 authorizing" on the service desktop. This authorizes STEP 7 and it
PCU-Basesoftware (IM8)
Commissioning Manual, 03/2009, 6FC5397-1DP10-4BA0
directory there.
should be changed to F:\... where the directory in F: can be freely selected.
keys later." The licensing is done after the installation of SINUMERIK add-on. Once
installation is complete, the PC will need to be rebooted. During boot up, select the
service desktop again.
installation proceeds with operator prompting. Once installation is complete, the PC will
need to be rebooted. During boot up, select the service desktop again.
can now be started from the HMI Advanced operator interface (STEP 7 appears as its
own operating area on the expansion bar of the area menu, protected with access
level 3).
3.3 How to install and authorize SIMATIC STEP 7
SIMATIC STEP 7 V5.4 SP1
SIMATIC STEP 7 V5.4 SP1 and
Add-on for SINUMERIK 840Di sl/840D sl/840D
1 installation DVD
PCU-Basesoftware V8.0 or higher
A network connection or a connection to a DVD drive is required.
Recommendation: Mouse port
Install software and updates
57