Siemens SINUMERIK Commissioning Manual page 183

6.1.4 Select location type
Location types
In this screen, new location types are defined with the required data or existing ones are
displayed.
Figure 6-6
Location types
Name
Display
Hierarchy
Form type
Parameterization
Consider adjacent
location
HMI Advanced (IM4)
Commissioning Manual, 03/2009, 6FC5397-0DP10-3BA0
Start-up: Location types
Name of the location type (max. 32 characters).
Language-dependent name of the magazine. If it exists, the display text is
immediately displayed from patm_xx.ini.
To overcome the inflexible classification of magazine locations according to
location type, locations can be arranged in ascending order, i.e. in a hierarchy
(see Section "Hierarchy of location types").
The position of the reference location (tool shank) is specified via the form
type.
Definition of height and width as well as free half locations (left, right, top,
bottom) (see examples).
This information is stored magazine specifically (magazine configuration) and
it relevant for the location search.
6.1 Setting tool management parameters on the HMI
Tool management
177