Siemens SINUMERIK Commissioning Manual page 239

Coding of location status and tool status
Location statuses
G Disabled location
F
Z
B
L
R Right half location occupied
O Upper half location occupied
U Lower half location occupied
l
r
o
u
6.2.4 Parameterizing the display of bitmaps for tools
Parameter settings for bitmaps in the list
The display of the active tool, the programmed tool and the current location in the magazine
list can be freely parameterized, i.e. bitmaps can be inserted in the parameterizable columns
of individual lists. The bitmaps can be customized or created from scratch. The display is
activated in paramtm.ini.
The bitmaps described below are located in the "hmi_adv" directory.
Default bitmap settings
The bitmaps for the current tools are shown in red and those for the programmed tools are
shown in green.
Bitmap
HMI Advanced (IM4)
Commissioning Manual, 03/2009, 6FC5397-0DP10-3BA0
Free location
Reserved for tool in buffer
Reserved for tool to be loaded
Left half location occupied
Left half location reserved
Right half location reserved
Upper half location reserved
Lower half location reserved
Tool management
6.2 Settings in the configuration file
Tool statuses
G Disabled tool
F Released tool
A Active tool
M Measured tool
V Prewarning limit reached
W Tool is being changed
P Fixed location coded tool
E Tool has been in use
R Unloading marking
B Loading marking
S Master tool
Features
TNo. <> 0;
DNo./cutting edge no. <> 0
DLNo. <> 0
TNo. <> 0;
DNo./cutting edge no. = 0
DLNo. = 0
TNo. <> 0;
DNo./cutting edge no. <> 0;
DLNo. = 0
Current location
233