Siemens SINUMERIK Commissioning Manual page 217

ApplDataParamName8 = TC_MPPCS8
ApplDataParamName9 = TC_MPPCS9
ApplDataParamName10 = TC_MPPCS10
ApplDataParamIO1 = <EndOfList>
; ApplDataParamIO1 = Min:=-42, Max:=62
; ApplDataParamIO2 = Min:=-210, Max:=712
ApplDataParamSize = TC_MPPCS_UNIT
ApplDataParamSize1 = <EndOfList>
; ApplDataParamSize1=TC_MPPCS1_UNIT
; ...
; ApplDataParamSize10=TC_MPPCS10_UNIT
Parameterization of the individual magazine, tool and working offset lists
; From changes in the following sections it is possible to determine
; which data is to be displayed in the individual magazine, tool and
; working offset lists.
; [1_MagList], [2_MagList], [3_MagList],
; [1_ToolList], [2_ToolList], [3_ToolList],
; [1_ActList], [2_ActList], [3_ActList].
; In these sections you can determine the number of
; columns that are not moved (i.e. always visible) during
; horizontal navigation ("NrOfFixedColumns=") and the
; individual columns "1=...", "2=...", etc.).
; The column number (number in front of "=") can take a value
between
; 1 and 1000. The maximum number of columns in a
; list is around 90, although with 90 columns in a
; list the display speed will slow down and
; the user will have to scroll horizontally in order to be able to
; view all the columns, so as a general rule this limit is
; not reached.
; Gaps are allowed between the numbers in the sequence of
; column numbers.
; To disable a column predefined in mmc2\paramtm.ini,
; in the user\paramtm.ini you can
; add the corresponding entry with the value "<Empty>".
; Specify "...=<EndOfList>" to define the end of
; the list. This increases the speed when reading
; the INI files after starting tool management.
; Example for the syntax of a column-definition line:
; "2=TC_TP2,11,TC_TP2 ; WzIdent "2": Number of the entry
; for first "TC_TP2": determines which NC data in the list of
columns
; will be displayed. The character string TC_TP2 corresponds to an
; NCK variable, see programming manual.
; The specified character strings are described in paramtm.txt.
; New in Version P5:
HMI Advanced (IM4)
Commissioning Manual, 03/2009, 6FC5397-0DP10-3BA0
Tool management
6.2 Settings in the configuration file
211