Siemens SINUMERIK Commissioning Manual page 290

List of the INI Files
A.9 HEADER.INI
33=CondWait.bmp
34=CondWait.bmp
35=CondWait.bmp
36=CondWait.bmp
37=CondWait.bmp
38=CondWait.bmp
39=CondWait.bmp
40=CondWait.bmp
41=CondWait.bmp
42=CondWait.bmp
43=CondWait.bmp
44=CondWait.bmp
45=CondStop.bmp
46=CondWait.bmp
47=CondWait.bmp
48=CondWait.bmp
49=CondWait.bmp
50=CondWait.bmp
51=CondWait.bmp
52=CondWait.bmp
53=CondWait.bmp
54=CondWait.bmp
55=CondWait.bmp
56=CondWait.bmp
57=CondWait.bmp
58=CondWait.bmp
59=CondWait.bmp
60=CondWait.bmp
61=CondWait.bmp
62=CondWait.bmp
63=CondWait.bmp
64=CondWait.bmp
65=CondWait.bmp
66=CondWait.bmp
67=CondWait.bmp
68=CondWait.bmp
284
; Axis exchange active
; block change inhibited because axis exchange in progress
; Axis container rotation
; AXCT: Following axis active
; AXCT: Leading axis active
; AXCT: Follow up mode active
; AXCT: Internal status change
; AXCT: Axis/spindle inhibit
; AXCT: Corr. motion active
; Axis container exchange: Overlaid movement
; AXCT: Axis exchange active
; AXCT: Axis interpolator active
; Waiting for compile cycle
; Access to system variable
; Search target found
; (block search has found search target and the NCK has
stopped)
; Rapid retraction started
; AXCT: Waiting for spindle stop
; Axis container exchange
; Machine data alignment (;New-Config)
; Axis exchange: Axis in coupling
; Axis exchange: Liftfast active
; Axis exchange: New-Config active
; Axis exchange: AXCTSW active
; Axis exchange: WAITP active
; Axis in another channel
; Axis exchange: Axis PLC axis
; Axis exchange: Axis oscillating axis
; Axis exchange: Axis JOG axis
; Axis exchange: Command axis
; Axis exchange: Axis OEM axis
; Coupled following axis
; Coupled-motion following axis
; Coupled slave axis
; Stop at cycle end M0
; Stop at cycle end M1
; Wait: Axis is at endstop
; "Master-slave switchover active"
;"Axis exchange: Axis single axis"
; "Stop: Target reached after block search"
Commissioning Manual, 03/2009, 6FC5397-0DP10-3BA0
HMI Advanced (IM4)