Installation Precautions; Connecting The Telephone Cords; Figure 2-117 Connecting Telephone Cords To The Telephone Jack; Figure 2-118 Connecting The Dtl-8R-1 Cordless Dect To The Multiline Terminal - NEC SL1100 Hardware Manual

ISSUE 1.0
and telephone line jack. The base unit can also be mounted on a standard wall plate using the wall
mount adapter. Keep the base unit and handset away from sources of electrical noise (motors, fluores-
cent lighting, computers, PC monitor).

6.1.2 Installation Precautions

To ensure optimum performance follow these guidelines.
• Base units must be placed at least 20 feet apart.
• Always place the base unit on top of a desk or on higher shelves. Avoid locations surrounded by
metal surfaces.
• Place the base away from any electrical component such as a PC, monitor and other telephone.

6.1.3 Connecting the Telephone Cords

When connecting the telephone cords, observe the following precautions.
• Never install telephone wiring during a lightning storm.
• Never touch bare telephone wires or terminals unless the telephone line is
disconnected at the network interface.
• Use caution when installing or modifying telephone lines.
To connect the telephone cords:
1. Connect the cord from the telephone jack to the Line In on the DTL-8R-1 Cordless DECT.

Figure 2-117 Connecting Telephone Cords to the Telephone Jack

2. Connect a SL1100 digital multiline terminal to the DTL-8R-1 Cordless DECT.
Line "OUT"

Figure 2-118 Connecting the DTL-8R-1 Cordless DECT to the Multiline Terminal

Hardware Manual
To SL1100 Multiline Terminals
SL1100
2-73