Connector Pin-Out On The Exifu-B1 / E1 - NEC ux5000 Hardware Manual

Hide thumbs Also See for ux5000:
Table of Contents

Advertisement

Chapter 2 - Blade Installation and Startup
2.4.2
Expansion (EXIFU) Blade (Figure 2-10)
The EXIFU blade provides a connection from the Controlling Chassis-B to the Base Chassis-B
expansion unit. This connection is required with any multiple-chassis setup (a MEMDB is also
required for multiple-chassis setup). This blade allows the CCPU to transmit/receive data as
required to the additional chassis.
The EXIFU-
which is equipped with a CCPU blade. The EXIFU-
slot of the Base Chassis-B, which does not have a CCPU.
The EXIFU cable is used to connect the Controlling chassis and its EXIFU-
second, third, and fourth Base chassis EXIFU-
19" chassis to a 9.5" chassis or 2 combined 9.5" chassis.
Use only the CAT 5 cables provided by NEC to make the connections between the Base chassis
and Expansion chassis.
The EXIFU provides:
Refer to "2.4.1.2 DSP Resources" on page 2-17 for complete details on the DSP resource usage.
2.4.2.1

Connector Pin-Out on the EXIFU-B1 / E1

2 - 26
B1
blade (P/N 0911020) is installed in the EXIFU slot of the Controlling Chassis-B
Communication Processor Interface for data handling through Cch (18 slots max.)
64 Channels for Telephony Resource (ex: DTMF Tone Receiver, Call Progress Tone
Detector, MFC Tone Receiver, Caller ID Receiver, Caller ID Signal Sender)
DSP Resource Management
12345678
- P/N 0911020 and 0911022
E1
blade (P/N 0911022) is installed in the EXIFU
E1
interface. The EXIFU can be used to connect a
RJ61 Cable Connector -
EXIFU-B1 - CN2, CN3, CN 4
EXIFU-E1 - CN3
Pin No.
1
2
3
4
5
6
7
8
B1
interface to the
Connection
HW_UP (+)
HW_UP (-)
HW_DWN (+)
FS (+)
FS (-)
HW_DWN (-)
CK8M (+)
CK8M (-)
Chapter 2

Advertisement

Table of Contents
loading

Table of Contents