Suzuki Wagon R Manual page 977

9-36 BODY SERVICE
INSTALLATION
Reverse removal procedure for installation, noting the following
point.
1) Tighten glass fixing bolts (1) temporarily.
2) Position sliding roof glass by closing sliding roof glass complete-
ly.
3) Tighten glass fixing bolts (1).
Tightening Torque: Sliding roof bolt 4 N
ADJUSTMENT
1) Loosen sunroof glass fixing screws (at 4 locations) and move
sunroof glass up and down 2 to 3 times. In this way, sunroof
glass can be positioned in both vertical and horizontal directions
by elasticity of sliding roof weather strip.
Section A – A
2) Position sunroof glass by such dimensions with respect to roof
panel surface as specified below.
Dimension: "a": 0 mm (0.0 in.)
3) After installing all parts and adjusting properly, check sunroof for
proper operation (open, close and up).
SLIDING ROOF DEFLECTOR
REMOVAL
1) Open sliding roof.
2) Release lags (1) at both bearing points with pliers.
3) Detach deflector rod (2) and then remove sliding roof deflector
with rod.
4) Remove circlip (1) and pull off connecting pin (2).
5) Remove sliding roof deflector (3).
.
m (0.4 kg-m, 3 lb-ft)