Suzuki Wagon R Manual page 1371

7) Connect brake pipe to wheel cylinder and tighten brake pipe
flare nut to specified torque.
Tightening torque
Brake pipe flare nut (b) : 16 N·m (1.6 kg-m, 11.5 lb-ft)
8) Tighten oil drain plug to specified torque and refill rear axle
(differential) housing with new specified gear oil and tighten
oil filler plug to specified torque. Refer to Section 7F for tight-
ening torque data and refill.
9) Connect parking brake cable (1) to parking brake shoe lever.
Install brake shoes and secure parking brake cable to brake
back plate with clip (2).
Install wheel speed sensor (if equipped with ABS).
CAUTION:
Check to ensure that clip is in good condition before
installing it. If deformed or broken, replace.
10) Install brake drum (1) (right & left) after marking sure that
inside of brake drum and brake shoes are free from dirt and
oil. Then tighten wheel nuts (2) temporarily by hand.
11) Fill reservoir with brake fluid and bleed brake system. (For
bleeding operation, refer to "BLEEDING BRAKES" in Sec-
tion 5.)
12) Install wheel and tighten wheel nuts to specified torque.
13) Upon completion of all jobs, pull parking brake lever with
about 20 kg, (44 lbs) load three to five times so as to obtain
proper drum-to-shoe clearance.
Adjust parking brake cable (for adjustment, refer to "PARK-
ING BRAKE INSPECTION AND ADJUSTMENT" in Section
5).
14) Check to ensure that brake drum is free from dragging and
proper braking is obtained.
15) Perform brake test (foot brake and parking brake).
(For brake test, see Section 5.)
16) Check each installed part for oil leakage.
Rear Axle Shaft Oil Seal
REMOVAL
1) Remove rear axle shaft. For details, refer to steps 1) to 8) of
"REAR AXLE SHAFT AND WHEEL BEARING" in this sec-
tion.
REAR SUSPENSION 3E-7