Suzuki Wagon R Manual page 1056

1. Connect one banana plug to positive terminal of
power source (12V vehicle battery) and then the
other to negative terminal to immediately deploy.
2. Short to two deployment harness leads.
WARNING:
D After deployment/activation, the metal surfaces of the
air bag (inflator) module and the seat belt pretension-
er will be very hot. Do not touch the metal areas of
them for about 10 minutes after deployment/activa-
tion.
D Do not place the deployed air bag (inflator) module
and the activated seat belt pretensioner near any flam-
mable objects.
D Do not apply water, oil, etc. to deployed air bag (infla-
tor) module and activated seat belt pretensioner.
D If the deployed air bag (inflator) module and the acti-
vated seat belt pretensioner must be moved before it
is cool, wear gloves and handle it by using nonmetal
material such as the air bag, webbing and vinyl trim.
Failure to follow procedures may result in fire or per-
sonal injury.
12) Separate the two banana plugs on the deployment harness.
13) Connect the deployment harness to the power source (12 V ve-
hicle battery) to immediately deploy/activate the air bag or seat
belt pretensioner.
14) Disconnect the deployment harness from power source (12 V
vehicle battery) and short the two deployment harness leads
together by fully seating one banana plug into the other.
15) In the unlikely event that the air bag (inflator) module or seat
belt pretensioner did not deploy/activate after following these
procedures, proceed immediately with Steps 20) through 23).
If the air bag (inflator) module or the seat belt pretensioner did
deploy/activate, proceed with Steps 16) through 19).
16) Put on a pair of shop gloves to protect your hands from possible
irritation and heat when handling the deployed air bag (inflator)
module and the activated seat belt pretensioner.
17) Disconnect the deployment harness from the air bag (inflator)
module and the seat belt pretensioner as soon after deploy-
ment/activation as possible.
This will prevent damage to the deployment harness due to
possible contact with the hot air bag (inflator) module and seat
belt pretensioner. The deployment harness are designed to be
reused. They should, however, be inspected for damage after
each deployment/activation and replaced if necessary.
AIR BAG SYSTEM 10B-59