Suzuki Wagon R Manual page 914

WINDOWS, MIRRORS, SECURITY AND LOCKS 8D-23
POWER DOOR MIRROR CONTROL SYSTEM
(IF EQUIPPED)
MIRROR SWITCH
INSPECTION
1) Disconnect negative cable at battery.
2) Pull out mirror switch from door trim.
3) Disconnect mirror switch lead wire coupler.
4) Check continuity between terminals at each switch position.
If any continuity is not obtained, replace mirror switch.
L
a a
R
UP
DOWN
LEFT
RIGHT
DOOR MIRROR ACTUATOR
INSPECTION
1) Disconnect negative cable at battery.
2) Remove door trim. Refer to steps 1) to 5) of FRONT DOOR
GLASS REMOVAL in Section 9.
3) Disconnect door mirror coupler.
4) Check that door mirror operates properly when battery voltage
is applied to connector terminals.
Connect battery positive and negative terminal to the door mirror
terminal shown below.
If it does not operate as specified in table below, replace door
mirror assembly.
Terminal
Operation
Up
Down
Left
Right
5) Install door trim. Reverse removal procedure.
REMOVAL AND INSTALLATION
Refer to DOOR MIRROR REMOVAL AND INSTALLATION in Sec-
tion 9.
NOTE:
When installing door mirror to door, be careful not to pinch
harness between door and door mirror.
b b c c
a a b b c c




d g
e f