Suzuki Wagon R Manual page 1372

3E-8 REAR SUSPENSION
2) Remove rear axle shaft oil seal (1) by using special tool.
Special tool
(A) : 09913-50121
2. Axle housing
INSTALLATION
1) Using special tool, drive in oil seal (1) until it contacts oil seal
protector (2) in axle housing.
NOTE:
• Make sure that oil seal is free from inclination as it is
installed.
• Refer to figure so that oil seal is installed in proper
direction.
Special tool
(A) : 09924-84510-004
(B) : 09913-75821
"A" : Grease 99000-25010
A : Differential side
2) For procedure hereafter, refer to steps 4) to 16) of "REAR
AXLE SHAFT AND WHEEL BEARING" in this section.
Rear Axle Housing
REMOVAL
1) Remove rear axle shaft referring to item 1) to 8) of "REAR
AXLE SHAFT AND WHEEL BEARING" in this section.
2) Disconnect brake pipes (2) (right & left) from flexible hoses
(1) and remove E-rings (3).
3) Remove brake pipes from wheel cylinders (right & left).
4) Remove wheel speed sensors (right & left) and release
clamps from axle housing (if equipped with ABS).
5) Remove LSPV adjust nut and detach spring end from rear
axle housing (if equipped with LSPV).