Suzuki Wagon R Manual page 631

6G-14 CRANKING SYSTEM
12) Install packing (1) so that cuts in packing align with bolt holes
(2) for through bolts in front housing.
13) Install plate and seal rubber (3) to front housing (4).
14) Apply grease to ball (1) and install ball into shaft hole.
Grease: 99000-25010
15) Install yoke, armature, brush holder and rear bracket to front
housing by aligning match marks provided before removal.
16) Tighten through bolts (1).
17) Install magnetic switch assembly (1) and connect wire (switch
to motor) to switch terminal.
18) Upon completion of assembly, carry out PERFORMANCE
TEST. (Refer to page 6G-15.)