Suzuki Wagon R Manual page 1430

7A-14 MANUAL TRANSMISSION
17) Remove engine left mounting (1) with bracket (2).
18) Remove other attached parts from transmission, if any.
19) Pull transmission out so as to disconnect input shaft from
clutch disc and then lower it.
REMOUNTING
CAUTION:
Care should be taken not to scratch oil seal lip with drive
shaft while raising transmission.
Do not hit drive shaft joint with hammer when installing it
into differential gear.
Remount transmission in reverse order of dismounting procedure
noting the following.
• Set bolt (1) to the original position of transmission before
mounting transmission assembly to engine assembly.
• Refer to the first figure of "UNIT REPAIR OVERHAUL" in
Section 7A of the Service Manual mentioned in the FORE-
WORD of this manual for fastener specified torque.
• Refer to Section 7D for installing transfer.
• Push in drive shaft joints (right & left) fully so as to snap ring
of shaft engages with differential gear.
• Set each clamp for wiring securely.
• After connecting clutch cable, be sure to adjust its play prop-
erly.
Refer to Section 7C of the Service Manual mentioned in the
FOREWORD of this manual.
• Fill transmission and transfer with oil as specified.
• Connect battery and check function of engine, clutch and
transmission.