Suzuki Wagon R Manual page 700

1. Reverse gear shift arm 6. 5th & reverse gear shift
2. Reverse gear shift yoke
arm spring (Blue) 7. 5th & reverse gear shift
3. Steel ball guide shaft
4. Spring pin 8. 5th gear side
5. 5th & reverse gear shift A: Face pin slit toward 5th
shaft gear side
1. Differential case
2. Differential gear
3. Differential pinion shaft
5TH & REVERSE GEAR SHIFTER
1) Disassemble component parts by using special tool and ham-
mer.
Special Tool
(A): 09922-85811 (4.5 mm)
2) Replace or correct parts as required and assemble shafts mak-
ing sure that component parts are in proper order as shown in
figure.
NOTE:
D Distinguish reverse gear shift arm spring (Blue) (2) from
low speed locating spring (Yellow).
D Install 2 steel balls (3) in reverse gear shift arm (1) without
fail.
D Drive in spring pin for reverse shift arm facing slit A to-
ward front.
DIFFERENTIAL ASSEMBLY
DISASSEMBLY
1) Using special tools, remove right bearing (1) and sensor rotor
(2).
Special Tool
(A): 09913-60910
(B): 09925-88210
2) Remove left bearing in the same manner.
3) Support differential case with soft jawed vise and remove final
gear bolts then take out final gear.
4) Using special tool and hammer, drive out differential side pinion
shaft pin and then disassemble component parts.
Special Tool
(C): 09922-85811 (4.5 mm)
MANUAL TRANSMISSION 7A-29