Suzuki Wagon R Manual page 795

7B-84 AUTOMATIC TRANSMISSION (4 A / T)
6) Install snap ring (1).
NOTE:
Make sure that the ends of the snap ring do not come to the
opening of the front clutch No.1 drum.
7) Place special tool (A) on soft jawed vise (1) and install 2 oil seal
rings on special tool.
Special Tool
(A): 09926-26030
SUZUKI GENUINE PARTS
(B): Clutch drum seal ring 22831-83E10
NOTE:
D Clutch drum seal set has two seal rings in a set.
D Do not use the seal rings removed from oil pump ass'y. It
is not necessary to remove seal rings from special tool
once installed.
8) Place front clutch assembly (1) on special tool (A).
9) Set dial gauge (4) on the top of clutch flange and measure clear-
ance by blowing compressed air (4 kg/cm
figure.
Clearance: 0.47 – 1.14 mm (0.0185 – 0.0448 in.)
If the clearance is out of specification, replace clutch discs,
plates and flange.
2. Snap ring
3. Air gun
2
, 57 psi) as shown in