Suzuki Wagon R Manual page 1481

Drive bevel pinion bearing outer race
For press-fitting drive bevel pinion bearing outer races, use spe-
cial tools as shown.
CAUTION:
Perform press-fitting carefully so as not to tilt outer race.
Special tool
(A) : 09924-74510
(B) : 09925-68210
(C) : 09951-16090
Differential case assembly
1) Assemble differential gears and measure thrust play of differ-
ential gear (2) as follows.
Special tool
(A) : 09900-20607
(B) : 09900-20701
Differential gear thrust play
0 – 0.37 mm (0 – 0.014 in.)
[A] : Right side
[B] : Left side
Right side
• Hold differential assembly with soft jawed vise and apply
measuring tip of dial gauge to top surface of gear (2).
• Using 2 screwdrivers (1), move gear (2) up and down and
read movement of dial gauge pointer.
Left side
• Using similar procedure to the above, set dial gauge tip to
gear shoulder.
• Move gear (2) up and down by hand and read dial gauge.
2) If thrust play is out of specification, select suitable differential
gear washer from among following available size, install it
and check again that specified gear play is obtained.
Available differential gear washer thickness
0.90, 1.00 and 1.10 mm (0.035, 0.039 and 0.043 in.)
REAR DIFFERENTIAL 7F-11