Suzuki Wagon R Manual page 1393

4) Remove nut (2) and detach spring end from bracket (3).
5) Remove LSPV assembly (1) with spring (4) from vehicle
body.
INSTALLATION
1) Install LSPV assembly with spring to vehicle body.
2) Tighten brake pipe flare nuts and LSPV adjusting nut (1) to
specified torque.
Special tool
(A) : 09950-78230 (10 x 11 mm)
Tightening torque
LSPV adjust nut (a) : 25 N·m (2.5 kg-m, 18.0 lb-ft)
Brake pipe flare nut (b) : 16 N·m (1.6 kg-m, 11.5 lb-ft)
3) Fill reservoir with specified fluid and bleed air from brake
system.
4) After bleeding air, check that LSPV is installed properly refer-
ring to following "INSPECTION & ADJUSTMENT".
INSPECTION & ADJUSTMENT
1) Confirm the following before inspection and adjustment.
• Fuel tank is filled with fuel fully.
• Vehicle is equipped with spare tire, tools, jack and jack han-
dle.
• Vehicle is free from any other load.
• Vehicle is placed on level floor.
BRAKES PIPE/HOSE/MASTER CYLINDER 5A-5