Suzuki Wagon R Manual page 1007

10B-10 AIR BAG SYSTEM
AIR BAG DIAGNOSTIC SYSTEM CHECK FLOW TABLE
STEP
1 1) Make sure that battery voltage is
about 11 V or higher.
2) Note air bag warning lamp as
ignition switch is turned ON.
3) Does air bag warning lamp come ON or
flash when ignition switch is turned ON?
2 Does air bag warning lamp come ON
steady?
3 Does air bag warning lamp keep flashing
(indicating DTC) even after initial 6-time
flashing when ignition switch is ON?
4 Does air bag warning lamp turn OFF,
after flashing 6 times?
5 1) Check DTC. Refer to DTC CHECK.
2) Not using SUZUKI scan tool:
Is DTC 12 indicated?
Using SUZUKI scan tool:
Is "NO DTC" displayed?
6 1) Check DTC. Refer to DTC CHECK.
2) Not using SUZUKI scan tool:
Is DTC 12 indicated?
Using SUZUKI scan tool:
Is "NO DTC" displayed?
ACTION YES
Go to step 2.
Air bag warning lamp come
ON steady.
Proceed to Table A.
Air bag warning lamp
flashes.
Proceed to Table C.
Go to step 5.
Air bag system is in good
condition.
Substitute a known-good
SDM and recheck.
NO
Air bag warning lamp
does not come ON.
Proceed to Table B.
Go to step 3.
Go to step 4.
Go to step 6.
An intermittent trouble has
occurred at some place.
Check the connector
harness, etc. related to
the sensed DTC.
Refer to INTERMITTENT
AND POOR
CONNECTIONS in this
section.
Then clear DTC (Refer to
DTC CLEARANCE) and
repeat this table.
Check and repair
according to Flow Table
corresponding to that DTC.