Suzuki Wagon R Manual page 827

7B-116 AUTOMATIC TRANSMISSION (4 A / T)
1. Rear cover
4. Gasket
21) Install thrust needle roller bearing (3).
22) Install thrust washer (2).
23) Install new gasket to transmission case and install rear cover
(1).
Tightening Torque:
.
(a): 19 N m (1.9 kg-m, 14.0 lb-ft)
NOTE:
Install the hook (2) to the location shown in figure.
(a)
24) Measure clearance of thrust washer and rear cover in the fol-
lowing manner.
Measure the shaft and play of planetary set (1) with dial gauge
(2).
NOTE:
Make sure that tip of dial gauge is not in contact with
counter drive gear (3).
Standard Value for Clearance: 0.3 – 0.7 mm
If the obtained clearance is out of specification, select the thrust
washer from table below and repeat above steps 22) – 24) to
obtain the clearance within specification.
Available thrust washer
(0.012 – 0.028 in.)
(thickness)
1.9 mm (0.075 in.)
2.2 mm (0.087 in.)
2.5 mm (0.098 in.)
2.8 mm (0.110 in.)