Suzuki Wagon R Manual page 704

7) Clean mating surfaces of both right and left cases, coat mating
surface of left case (1) with sealant evenly then mate it with
right case (2).
"B": Sealant, Bond No.1215, 99000-31110
8) Tighten case bolts (3) from left case side to specified torque.
Tightening Torque
(b): 19 N
9) Install reverse shaft bolt (4) applied with thread lock cement
with aluminum washer and tighten it.
"A": Thread lock 1322, 99000-32110
Tightening Torque
(c): 23 N
10) Install another case bolts from clutch housing side and tighten
them to specification.
11) Check locating spring for deterioration and replace with new
one as necessary.
Locating spring free length
Low speed (3) and 5th &
reverse (6)
1, (d)
High speed (5)
12) Install steel ball (4) and locating spring for respective gear shift
shaft and tighten with bolt (1) and washer (2).
Tightening Torque
(d): 13 N
.
m (1.9 kg-m, 14.0 Ib-ft)
.
m (2.3 kg-m, 17.0 lb-ft)
(1.028 in.)
(1.579 in.)
.
m (1.3 kg-m, 9.5 Ib-ft)
MANUAL TRANSMISSION 7A-33
Standard Service Limit
26.1 mm 25.0 mm
(0.984 in.)
40.1 mm 39.0 mm
(1.535 in.)