Suzuki Wagon R Manual page 641

6G1-6 CRANKING SYSTEM
DISASSEMBLY
NOTE:
D Before disassembling starting motor, be sure to put match
marks at two locations (A and B) as shown in left figure so
that any possible mistakes can be avoided.
D Do not clamp yoke in a vise or strike it with a hammer during
disassembling and reassembling.
1) Remove nut securing the end of field coil lead to terminal on the
head of magnetic switch.
2) Take off magnetic switch (1) by removing 2 mounting screws.
NOTE:
1
Don't disassemble this switch. If defective, replace as a
complete assembly.
2
3) Loosen 2 bolts and 2 screws to remove rear bracket (2).
4) Separate front housing (1) and armature (2) from yoke (3).
5) Draw brushes out of brush holder.