Suzuki Wagon R Manual page 1460

7D-16 TRANSFER
7) Select adjusting shim closest to calculated value from
among the following available sizes.
Available shims thickness
: 0.30, 2.00, 2.03, 2.06, 2.09, 2.12, 2.15, 2.18, 2.21, 2.24 and
2.27 mm (0.012, 0.079, 0.080, 0.081, 0.082, 0.083, 0.085,
0.086, 0.087, 0.088 and 0.089 in.)
8) Disassemble bevel pinion dummy and special tools.
9) Press-fit pinion shaft bearing (front side) by using special
tool, hydraulic press and pinion shaft spacer (1) removed in
procedure "Unit Disassembly Transfer Output Retainer
Assembly" in this section.
Special tool
(A) : 09913-75810
10) Install bevel pinion shaft with new pinion shaft spacer (1) to
transfer output retainer.
CAUTION:
Press-fit bearing to such an extent that spacer is not
compressed. Excessive compression may cause a failure
in bearing preload adjustment.
11) Press-fit pinion shaft bearing (rear side) (2) by using special
tool and hydraulic press.
Special tool
(A) : 09913-75810
12) Drive in new oil seal (1) by using special tools and apply
grease to oil seal lip.
Special tool
(A) : 09924-74510
(B) : 09926-27610
"A" : Grease 99000-25010
Transfer bevel pinion shaft oil seal installing depth
"a" : 27.0 – 27.5 mm (1.063 – 1.083 in.)
2. Bevel pinion shaft