Suzuki Wagon R Manual page 1239

6A-48 ENGINE MECHANICAL
A: Camshaft pulley side
INSTALLATION
1) Remove old gasket and oil on mating surfaces and install new
head gasket (1) as shown in figure so that check valve of cylinder
block and the hole (2) for check valve of cylinder head gasket
align.
2) Apply engine oil to cylinder head bolts and tighten them gradual-
ly as follows.
a) Tighten all bolts to 37 N
numerical order in figure.
b) In the same manner as in a), tighten them to 58 N
(5.8 kg-m, 42.0 lb-ft).
c) Loosen all bolts until tightening torque is reduced to 0 (zero)
in reverse order of tightening.
d) In the same manner as in a), tighten them to 37 N
(3.7 kg-m, 27.0 lb-ft).
e) In the same manner as in a) again, tighten them to specified
torque.
Tightening Torque
.
(a): 75 N m (7.5 kg-m, 54 lb-ft)
3) Install rubber seal (3) between water pump (2) and cylinder head
(1).
4) Install cylinder head cover.
5) Install timing belt as previously outlined.
6) Reverse removal procedure for installation, nothing the follow-
ing points.
D Adjust drive belt tension, referring to "ENGINE COOLING"
section.
D Adjust A/C compressor belt tension, if equipped.
Refer to Section 1B.
D Adjust accelerator cable play. Refer to Section 6E1.
D Check to ensure that all removed parts are back in place.
Reinstall any necessary parts which have not been reinstalled.
D Refill cooling system referring Section 6B.
D Connect negative cable at battery.
D Confirm that ignition timing is within specification referring to
"IGNITION SYSTEM" section.
D Verify that there is no fuel leakage, water leakage and exhaust
gas leakage at each connection.
.
m (3.7 kg-m, 27.0 lb-ft) according to
.
m
.
m