Suzuki Wagon R Manual page 1264

(a)
3) Install crankshaft to cylinder block.
4) Install bearing cap to cylinder block, making sure to point arrow
mark (on each cap) to crankshaft pulley side. Fit them sequen-
tially in ascending order, 1, 2, 3 and 4, starting from pulley side.
Gradual and uniform tightening is important for bearing cap
bolts. Make sure that four caps become tight equally and pro-
gressively till specified torque is attained.
Tightening Torque
(a): 53 N
NOTE:
After tightening cap bolts, check to be sure that crankshaft
rotates smoothly when turning it by 7.0 N
torque or below.
5) Install new gasket and oil seal housing.
Do not reuse gasket removed in disassembly. Apply engine oil
to oil seal lip before installation. Tighten housing bolts to specifi-
cation.
Tightening Torque
(a): 11 N
NOTE:
As there are 2 types of housing bolts, refer to figure for their
correct use.
After installing oil seal housing, gasket edges might bulge out;
it so, cut them off to make them flush with cylinder block and oil
seal housing.
6) Install oil pump.
Refer to INSTALLATION of OIL PUMP in this section.
1. Short bolts
2. Long bolts
7) Install flywheel.
Using special tool, lock flywheel or drive plate, and torque its
bolts to specification.
Special Tool
(A): 09924-17810
Tightening Torque
(a): 76 N
.
m (5.3 kg-m, 38.5 lb-ft)
.
m (1.1 kg-m, 8.0 lb-ft)
.
m (7.6 kg-m, 55.0 lb-ft)
ENGINE MECHANICAL 6A-73
.
m (0.7 kg, 5.1 lb-ft)