Suzuki Wagon R Manual page 1484

7F-14 REAR DIFFERENTIAL
3) Assemble pinion form dummy by using special tools.
Special tool
(A) : 09922-76140
(B) : 09922-76430
4) Apply gear oil to drive bevel pinion rear bearing, install bear-
ing to pinion form dummy and then install pinion form dummy
to differential carrier.
5) Apply gear oil to drive bevel pinion front bearing and install
bearing to pinion form dummy with other special tools as
shown in figure.
Special tool
(A) : 09922-76350
(B) : 09922-76150
(C) : 09922-76340
(D) : 09922-76430
(E) : 09922-76140
NOTE:
This installation requires no spacer or oil seal.
6) Tighten pinion form dummy nut (special tool) (1) so that
specified bearing preload is obtained.
NOTE:
Before taking measurement, check for rotation by hand
more than 15 revolutions.
Drive bevel pinion bearing preload (at 50 rpm)
0.5 – 1.3 N·m (5.0 – 13.0 kg-cm, 0.35 – 0.90 lb-ft)
7) Set dial gauge to bearing form dummy with dummy shaft and
make 0 (zero) adjustment on surface plate.
NOTE:
• When setting dial gauge to bearing form dummy with
dummy shaft, tighten screw lightly. Be careful not to
overtighten it, which will cause damage to dial gauge.
• With dial gauge set, turn dummy back and forth by
hand a couple of times and attain accurate 0 (zero)
adjustment.