Suzuki Wagon R Manual page 1015

10B-18 AIR BAG SYSTEM
Table C: AIR BAG WARNING LAMP FLASHES EVEN AFTER INITIAL 6-TIME FLASHING
STEP
1 1) Check air bag monitor coupler.
Is diagnosis switch terminal in air bag
monitor coupler grounded by service wire?
2 1) With ignition switch OFF, disconnect
SDM connector.
2) Check continuity between Q06-8
terminal of SDM connector and body
ground. (See figure below.)
Is there continuity?
Fig. for STEP 2
1. SDM connector
NOTE:
Upon completion of inspection and repair work, perform following items.
1) Reconnect all air bag system components, ensure all components are properly mounted.
2) Repeat "Air Bag Diagnostic System Check" in this section to confirm that the trouble has been cor-
rected.
ACTION YES
Go to step 2.
Repair short from "V" wire
circuit to ground.
Special Tool
(A): 09932-76010
NO
Remove service wire.
Substitute a known-good
SDM and recheck.