Suzuki Wagon R Manual page 1252

10) Disconnect following electric wires:
D Back-up light switch
D Generator
D Starting motor
D CKP sensor
D Battery negative cable from transmission
D Vehicle speed sensor
D e.t.c.
and release above wire harness from clamps.
11) Disconnect fuel feed hose (1) and fuel return hose (2) from fuel
pipes.
12) Disconnect heater inlet and outlet hoses.
13) Remove right and left engine under covers.
14) Disconnect oxygen sensor No.2 coupler (1) and remove ex-
haust No.1 pipe (2).
15) Drain engine and transmission oil.
16) Remove stabilizer bar (1) referring to Section 3D of the Service
Manual mentioned in FOREWORD of this manual.
1
17) Remove drive shaft joints from differential gear of transmis-
sion.
Refer to Section 4 (DRIVE SHAFT) of the Service Manual men-
tioned in FOREWORD of this manual for procedure to discon-
nect drive shaft joint.
For engine and transmission removal, it is not necessary to re-
move drive shafts from steering knuckle.
ENGINE MECHANICAL 6A-61