Suzuki Wagon R Manual page 1386

5-2 BRAKES
Check and Adjustment
Fluid Pressure Test (If Equipped with LSPV)
Test procedure for LSPV assembly is as follows.
Before testing, confirm the following.
• Fuel tank is filled with fuel fully.
• Vehicle is equipped with spare tire, tools, jack and jack han-
dle.
1) Place vehicle on level floor and set approximately about
1,000 N (100 kg, 220 lbs) weight (1) on rear housing center
so that rear axle weighs 4,500 N (450 kg, 992 lbs).
Rear axle weight "L" : 4,500 N (450 kg, 992 lbs)
2) Install special tool to front and rear brake.
NOTE:
Pressure gauge should be connected to bleeder plug
hole of front (left side brake) and rear (right side brake).
After testing front left side and rear right side, test front
right side and rear left side in the same way.
Special tool
Front brake
(A) : 09956-02310
(B) : 09952-36310
(C) : 55473-82030 (Air bleeder plug as a spare part)
NOTE:
For front brake, use special tool (B) instead of thread
diameter 10 mm attachment included in special tool (A).
Rear brake
(A) : 09956-02310
(C) : 55473-82030 (Air bleeder plug as a spare part)
(D) : 09952-48320