Suzuki Wagon R Manual page 834

1. C1 accumulator piston
2. C1 accumulator outer spring (with Yellow paint)
3. C1 accumulator inner spring (with Yellow paint)
4. Spacer
5. Snap ring
6. B0 accumulator piston
7. B0 accumulator spring (with Purple paint)
8. C0 accumulator piston
9. C0 accumulator spring (with Pink point)
10. B1 accumulator piston
11. B1 accumulator spacer
12. B1 accumulator inner spring (with Orange paint)
13. B1 accumulator outer spring (with Orange paint)
14. C2 accumulator piston
15. C2 accumulator inner spring (with Light Blue paint)
16. C2 accumulator outer spring (with Light Blue paint)
50) Install O-rings to each accumulator piston and apply grease or
ATF to them.
Grease 99000-25030
NOTE:
C1 and B0 accumulator pistons are the same.
51) Install C1 and B0 accumulator pistons (1 and 6), springs (2, 3
and 7) and spacers (4).
Hold them with snap rings (5).
NOTE:
D Make sure that snap rings are fitted to the groove of each
cylinder.
D Make sure that O-rings are not twisted or caught when
installing.
52) Install C0, B1, C2 accumulator springs (9, 12, 13, 15 and 16),
spacer (11) and pistons (8, 10 and 14) as shown in figure.
NOTE:
Make sure that O-rings are not twisted or caught when
installing.
53) Install wire-to-solenoid assembly (1).
NOTE:
Apply grease to O-ring of wire-to-solenoid ass'y.
Tightening Torque:
.
(a): 8 N m (0.8 kg-m, 6.0 lb-ft)
Grease 99000-25030
AUTOMATIC TRANSMISSION (4 A / T) 7B-123