Suzuki Wagon R Manual page 996

INSPECTION
WARNING:
Never measure resistance of pretensioner or disassemble
it. Otherwise, personal injury may result.
CAUTION:
If seat belt pretensioner (retractor assembly) was dropped
from a height of 30 cm (1 ft) or more, it should be replaced.
Seat belts and attaching parts can affect the vital components and
systems of a vehicle.
Therefore, they should be inspected carefully and replaced with
genuine parts only.
D Seat belt
Its webbing or strap should be free from damage.
D Retractor assembly
It should lock webbing when pulled quickly.
The front seat belt retractor assembly should pass the above in-
spection and should lock webbing even when tilted (approx. 15_)
toward the fore and aft or right and left directions.
D Anchor bolt
Anchor bolts should be torqued to specification.
D Belt latch
It should be secure when latched.
Check retractor assembly with seat belt pretensioner appearance
visually for the following symptoms and if any one of them is appli-
cable, replace it with a new one as an assembly.
D Pretensioner has activated.
D There is a crack in seat belt pretensioner (retractor assembly).
D Wire harness or connector is damaged.
D Seat belt pretensioner (retractor assembly) is damaged or a
strong impact (e.g., dropping) was applied to it.
INSTALLATION
Install seat belts in reverse order of removal, noting the following.
D Tighten bolts to specified torque.
D Connect Yellow connector for seat belt pretensioner securely.
D Connect negative battery cable to battery.
D Enable air bag system. Refer to "Enabling Air Bag System" under
"Service Precautions" in SECTION 10B.
SEAT BELT 10A-5