Suzuki Wagon R Manual page 1055

10B-58 AIR BAG SYSTEM
For Driver Air Bag (Inflator) Module
For Passenger Air Bag (Inflator) Module
1. Stretch deployment harness to full length
10 m (33 ft).
2. Connect connectors.
3. Power source (12V vehicle battery).
4. Short the two deployment harness leads.
5. Air bag wire harness attached to passenger
air bag module.
6) Stretch the deployment harness from the driver or passenger
air bag (inflator) module to its full length 10 m (33 ft).
Special Tool
(A): 09932-75030
(B): 09932-78320
7) Place a power source near the shorted end of the deployment
harness. Recommended application: 12 Volts minimum, 2
amps minimum. A vehicle battery is suggested.
8) Verify that the area around the driver or passenger air bag (in-
flator) module is clear of all people and loose or flammable ob-
jects.
9) [In case of Driver Air Bag (Inflator) Module]
Verify that the driver air bag (inflator) module is resting with its
vinyl trim cover facing up.
Use wire harness as adaptor cable which is attached to pas-
senger air bag module.
[In case of Passenger Air Bag (Inflator) Module]
Verify that the passenger air bag (inflator) module is firmly and
properly secured in passenger air bag (inflator) module deploy-
ment fixture (special tool).
[In case of Seat Belt Pretensioner]
Verify that the seat belt pretensioner, with its warning label at-
tached side facing up as shown in the figure on the ground in
the space just cleared.
Connect adaptor cable to pretensioner and air bag wire har-
ness as necessary.
Special Tool
(B): 09932-78320
10) Connect the air bag (inflator) module or seat belt pretensioner
to the deployment harness connector and lock connector with
lock lever.
11) Notify all people in the immediate area that you intend to
deploy/activate the air bag (inflator) module or seat belt Preten-
sioner.
NOTE:
D When the air bag deploys and the pretensioner acti-
vates, the rapid gas expansion will create a substantial
report. Wear suitable ear protection. Notify all people in
the immediate area that you intend to deploy the air bag
(inflator) module or to activate the seat belt pretensioner
and suitable ear protection should be worn.
D When the air bag deploys and the pretensioner acti-
vates, air bag (inflator) module and pretensioner (retrac-
tor assembly) may jump about 30 cm (1 ft) vertically. This
is a normal reaction of them to the force of the rapid gas
expansion inside the air bag and pretensioner.
D After the air bag (inflator) module has been deployed, the
surface of the air bag may contain a powdery residue.
This powder consists primarily of cornstarch (used to lu-
bricate the bag as it inflates) and byproducts of the
chemical reaction.