VALVE BODY ASSEMBLY
Assembly
1) Install gasket for lower valve body (3), valve body plate (2) and
gasket for upper valve body (1) to lower valve body (4).
2) Make sure that steel balls (2) are at the location shown in figure.
1. Upper valve body
3) Assemble lower valve body with gaskets and plate over upper
valve body.
First tighten bolts A then the other bolts.
Tightening Torque
(a): 5.5 N
NOTE:
D Be careful not to fall steel balls off.
D There are four kinds of bolts fixing upper and lower valve
body. Refer to the table below for the bolt specifications.
1. Bolt A
2. Bolt B
3. Bolt C
4. Bolt D
4) Install manual valve to valve body ass'y.
AUTOMATIC TRANSMISSION (4 A / T) 7B-103
.
m (0.55 kg-m, 4.0 lb-ft)
Bolt
Length "a"
A
20 mm (0.79 in.)
B
23 mm (0.91 in.)
C
29.5 mm (1.16 in.)
D
42 mm (1.65 in.)
Pieces
2
2
3
5