Suzuki Wagon R Manual page 1101

GENERAL INFORMATION AND ENGINE DIAGNOSIS 6-1-9
PRECAUTION IN DIAGNOSING TROUBLE
D Don't disconnect couplers from ECM (PCM), battery cable from
battery, ECM (PCM) ground wire harness from engine or main
fuse before confirming diagnostic information (DTC, freeze frame
data, etc.) stored in ECM (PCM) memory. Such disconnection will
erase memorized information in ECM (PCM) memory.
D Diagnostic information stored in ECM (PCM) memory can be
cleared as well as checked by using SUZUKI scan tool (Tech-1)
or generic scan tool. Before using scan tool, read its Operator's
(Instruction) Manual carefully to have good understanding as to
what functions are available and how to use it.
D Priorities for diagnosing troubles.
If two or more DTCs are stored, proceed to the flow table of the
DTC which has detected earliest in the order and follow the
instruction in that table.
If no instructions are given, troubleshoot diagnostic trouble codes
according to the following priorities.
1. Diagnostic trouble codes (DTCs) other than DTC P0171/
P0172 (Fuel system too lean/too rich) and DTC P0300/
P0301/P0302/P0303 (Misfire detected)
2. DTC P0171/P0172 (Fuel system too lean/too rich)
3. DTC P0300/P0301/P0302/P0303 (Misfire detected)
D Be sure to read "Precautions for Electrical Circuit Service" in Sec-
tion 0A before inspection and observe what is written there.
D ECM (PCM) Replacement
When substituting a known-good ECM (PCM), check for following
conditions. Neglecting this check may cause damage to a known-
good ECM (PCM).
– Resistance value of all relays, actuators is as specified respec-
tively.
– MAP sensor and TP sensor are in good condition and none of
power circuits of these sensors is shorted to ground.