Suzuki Wagon R Manual page 1265

6A-74 ENGINE MECHANICAL
8) Install pistons and connecting rods as previously outlined.
9) Install oil pump strainer and oil pan as previously outlined.
10) Install cylinder head assembly to cylinder block (1).
Before installing cylinder head assembly to cylinder block,
install check valve (2) into oil gallery in cylinder block, directing
slit of valve toward top of cylinder block.
NOTE:
Tighten cylinder head bolts to specified torque as pre-
viously outlined.
Whenever installing cylinder head to new cylinder block,
use following procedure to tighten cylinder head bolts.
D Tighten cylinder head bolts to specified torque as pre-
viously outlined and loosen them once till tightening
torque becomes "zero". And then torque them to specifi-
cation again.
11) Install crankshaft timing belt pulley, timing belt, crankshaft
pulley, water pump pulley, etc., as previously outlined.
12) Install clutch to flywheel.
For clutch installation, refer to Section 7C.
13) Install engine with transmission to body as previously outlined.