Suzuki Wagon R Manual page 1416

6A1-6 ENGINE MECHANICAL
INSTALLATION
1) Lift engine with transmission and transfer into engine com-
partment, but do not remove support device.
2) Install engine right mounting bracket bolts and nut.
3) Install engine left mounting nuts.
4) Install engine rear mounting bush bolt.
5) Tighten bolts and nuts to specified torque referring to the fig-
ure of "Engine Mounting" in this section.
6) Remove support device.
7) Reverse removal procedures for installation of remainder.
• Install A/C compressor bracket and A/C compressor and
connect A/C suction and discharge hoses, refer to Section
1B of the Service Manual mentioned in the FOREWORD of
this manual.
• Push in each drive shaft joint fully so that snap ring engages
with differential gear and intermediate shaft of transfer.
Use care not to damage oil seal lip when inserting.
• Install stabilizer bar, refer to Section 3D of the Service Man-
ual mentioned in the FOREWORD of this manual.
• Install exhaust No.1 pipe.
• Install right and left engine under covers.
• Connect each hoses securely.
• Clamp electric wire securely.
8) Adjust clutch pedal free travel, referring to Section 7C of the
Service Manual mentioned in the FOREWORD of this man-
ual.
Connect gear shift and select control cables referring to Sec-
tion 7A.
9) Refill transmission with gear oil referring to Section 7A of the
Service Manual mentioned in the FOREWORD of this man-
ual.
10) Refill engine with engine oil, referring to Section 0B of the
Service Manual mentioned in the FOREWORD of this man-
ual.
11) Refill cooling system, referring to Section 6B of the Service
Manual mentioned in the FOREWORD of this manual.
12) Adjust A/C compressor belt (if equipped), referring to Section
1B of the Service Manual mentioned in the FOREWORD of
this manual.
13) Upon completion of installation, verify that there is no fuel
leakage, coolant leakage, transmission oil leakage or
exhaust gas leakage at each connection.
14) Adjust accelerator cable play, referring to Section 6E of the
Service Manual mentioned in the FOREWORD of this man-
ual.