Suzuki Wagon R Manual page 1334

4) Remove two starting motor mount bolts (1).
5) Remove starting motor.
6) To install, reverse the above procedure.
DISASSEMBLY
NOTE:
D Before disassembling starting motor, be sure to put match
marks at two locations (A and B) as shown in left figure so
that any possible mistakes can be avoided.
D Do not clamp yoke in a vise or strike it with a hammer during
disassembling and reassembling.
1) Remove nut securing the end of field coil lead to terminal on the
head of magnetic switch.
2) Remove 3 nuts and then take out magnetic switch. Then remove
plunger by unhooking its hook from drive lever.
NOTE:
Don't disassemble this switch. If defective, replace as a
complete assembly.
3) Loosen 2 nuts and 2 screws and then pull out commutator end
housing.
CRANKING SYSTEM 6G2-5