Suzuki Wagon R Manual page 1035

10B-38 AIR BAG SYSTEM
DTC 44: DRIVER PRETENSIONER INITIATOR CIRCUIT SHORT TO POWER CIRCUIT
DTC 48: PASSENGER PRETENSIONER INITIATOR CIRCUIT SHORT TO POWER CIRCUIT
STEP
1 Was item "AIR BAG SYSTEM CHECK
FLOW TABLE" described in this section
performed?
2 1) With ignition switch OFF, remove center
pillar inner garnish of applicable side
then disconnect seat belt pretensioner
connector.
2) Check proper connection to applicable
seat belt pretensioner at terminals in
Q07 or Q05 connector.
3) If OK then connect Special Tools to seat
belt pretensioner connector
disconnected at 1). (See figure below.)
With ignition switch ON, is DTC 44 or 48 still
current?
3 1) With ignition switch OFF, disconnect
Special Tools and SDM.
2) Measure voltage from Q06-34 or Q06-36
terminal to body ground.
With ignition switch ON, is voltage 1 V or
less?
Fig. for STEP 2 and 3
Special Tool
(A): 09932-76010
(B): 09932-75010
(C): 09932-78310
NOTE:
Upon completion of inspection and repair work, perform following items.
1) Reconnect all air bag system components, ensure all components are properly mounted.
2) Clear diagnostic trouble codes (Refer to "Diagnostic Trouble Code (DTC) Clearance"), if any.
3) Repeat "Air Bag Diagnostic System Check" in this section to confirm that the trouble has been cor-
rected.
ACTION
Fig. for STEP 3
For DTC44
YES
Go to step 2.
Go to step 3.
Substitute a known-good
SDM and recheck.
NO
Perform "AIR BAG
SYSTEM CHECK FLOW
TABLE" in this section.
1) Ignition switch OFF.
2) Replace seat belt
pretensioner (Refer to
SECTION 10A).
DTC44:
Repair short "P" or "W"
wire circuit to power
circuit.
DTC48:
Repair short from "Lg" or
"Br" wire circuit to power
circuit.
For DTC48