Suzuki Wagon R Manual page 956

10) Apply adhesive referring to figure.
a
1. Molding
11) Holding rubber sucker grips (1), place glass onto body by align-
NOTE:
D Start from bottom side of glass (3).
D Be careful not to damage primer.
D Height of adhesive (2) applied to lower side should be
higher than that of other three sides.
Upper, right and left sides
Width "d": Approx. 7 mm (0.27 in.)
Height "e" : Approx. 15 mm (0.59 in.)
Position "f" : Approx. 10 mm (0.39 in.)
"g": Approx. 17 mm (0.67 in.) section "a"
D Press glass (3) against fittings surface of body panel
quickly after adhesive (2) is applied.
D Use of rubber sucker grip is helpful to hold and carry
glass after adhesive (3) is applied.
D Perform steps 8) to 9) within 10 min. to ensure sufficient
adhesion.
D Be sure to refer to adhesive maker's instruction for prop-
er handling and drying time.
ing mating marks marked in step 3) and press it.
BODY SERVICE 9-15