Suzuki Wagon R Manual page 1376

3E-12 REAR SUSPENSION
13) Apply grease to axle shaft oil seals (1) lip (right & left).
"A" : Grease 99000-25010
14) Clean mating surfaces (2) (right & left) of axle housing and
brake back plate and apply water tight sealant as shown in
figure.
"B" : Sealant 99000-31090
15) Install rear axle shaft (right & left) to rear axle housing and
tighten brake back plate bolts to specified torque.
Tightening torque
Brake back plate bolts (a) : 23 N·m (2.3 kg-m, 17.0 lb-ft)
16) Connect brake pipes (3) to wheel cylinders (1) (right & left)
and tighten brake pipe flare nuts (2) to specified torque.
Tightening torque
Brake pipe flare nuts (b) : 16 N·m (1.6 kg-m, 11.5 lb-ft)
17) Apply water tight sealant where brake back plate (1) and
parking brake cable contact.
Connect parking brake cable (2) to brake back plate (right &
left) and secure it with clip (3).
"A" : Sealant 99000-31090
NOTE:
Check to ensure that clip is in good condition before
installing it. If deformed or broken, replace.
18) Install brake shoes (right & left) referring to "BRAKE SHOE"
in Section 5C.
19) Install brake drums (1) (right & left) after making sure that
inside of brake drum and brake shoes are free from dirt and
oil. Then tighten wheel nuts (2) temporarily by hand.
20) Fill reservoir with brake fluid and bleed brake system. (For
bleeding operation, refer to Section 5.)
21) Refill differential gear housing with new specified gear oil.
Refer to Section 7F.
A : Forward