Suzuki Wagon R Manual page 1013

10B-16 AIR BAG SYSTEM
DIAGNOSTIC FLOW TABLE
Table A: AIR BAG WARNING LAMP COMES ON STEADY WITHOUT FLASHING
STEP
1 1) Check connections at Q03 and Q06
connectors with ignition switch OFF.
Are they properly connected and secured
by lock levers of couplers?
2 1) Ignition switch OFF.
2) Remove and inspect "AIR BAG" fuse.
Is fuse good?
3 1) Disconnect SDM connector.
2) Check proper connection to SDM at
terminal Q06-32.
3) If OK then check voltage between
Q06-32 terminal of SDM connector and
body ground with ignition switch ON.
(See figure below.)
Is it 8 V more?
4 1) Disconnect connector from combination
meter, referring to SECTION 8C.
2) Check continuity between Q06-30
terminal of SDM connector and body
ground. (See figure below.)
Is there continuity?
Fig. for STEP 3
1
1. SDM connector
Special Tool
(A): 09932-76010
NOTE:
Upon completion of inspection and repair work, perform following items.
1) Reconnect all air bag system components, ensure all components are properly mounted.
2) Repeat "Air Bag Diagnostic System Check" in this section to confirm that the trouble has been cor-
rected.
ACTION YES
Go to step 2.
Go to step 2.
Go to step 3.
"Bl" wire (between
combination meter and
SDM connector) short
to ground.
Fig. for STEP 4
1. SDM connector
NO
Reconnect and secure
them with lock levers.
"Bl/R" wire short to ground.
After repair, replace "AIR
BAG" fuse.
"Bl/R" wire (between
"AIR BAG" fuse and SDM
connector) open, "Bl/B"
wire (between ignition
switch and air bag fuse)
open or shorted to ground.
Substitute a known-good
SDM and recheck.