Suzuki Wagon R Manual page 1049

10B-52 AIR BAG SYSTEM
PASSENGER AIR BAG (INFLATOR) MODULE (IF EQUIPPED)
WARNING:
D Never attempt to disassemble or repair the passenger air bag (inflator) module. If any abnormality is
found, be sure to replace it with new one as an assembly.
D Be sure to read "Precautions" in this section before starting to work and observe every precaution
during work. Neglecting them may result in personal injury or undeployment of the air bag when nec-
essary.
REMOVAL
1) Disconnect negative battery cable from battery.
2) Open glove box (1) and remove clips (2).
3) Remove glove box (1).
NOTE:
When it is difficult to pull out glove box, pull out it while
pressing its stopper.
4) Disable air bag system. Refer to "Disabling Air Bag System" ear-
lier in this section.
5) Remove passenger air bag (inflator) module attaching bolts (3)
and passenger air bag (inflator) module (4) from vehicle.
WARNING:
Observe "Service Precautions" earlier in this section for
handling and storing it.
INSPECTION
WARNING:
Never measure resistance of passenger air bag (inflator)
module or disassemble it. Otherwise personal injury may
result.
CAUTION:
If air bag (Inflator) module was dropped from a height or 90
cm (3 ft) or more, it should be replaced.
Check air bag (inflator) module appearance visually for following
symptoms and if any one of them is applicable, replace with a new
one.
D Air bag has deployed.
D There is a crack in trim cover (pad surface).
D Wire harness or connector is damaged.
D Air bag (inflator) module is damaged or a strong impact (e.g.,
dropping) was applied to it.