Suzuki Wagon R Manual page 900

The illustration shows LH steering vehicle.
And RH steering vehicle is symmetrical.
WINDOWS, MIRRORS, SECURITY AND LOCKS 8D-9
AUTO STOP CIRCUIT
INSPECTION
1) Check that wiper motor operates with the wiper switch at low
position.
2) Disconnect negative cable at battery.
3) Disable air bag system. Refer to DISABLING AIR BAG SYSTEM
in Section 10B.
4) Pull out intermittent timer (1) and disconnect coupler, and con-
nect negative cable at battery.
5) Check that the voltage and resistance between following termi-
nals are specification.
Terminals
G51-8 and
ground
When wiper blades are
stopped at windshield
base.
Turn ignition switch to
G51-5 and
ON.
ground
Turn wiper switch to ON
then to OFF so that wiper
blades stop at the position
except starting/returning
point.
If check result is not satisfactory, repair and recheck.
6) Check the continuity between terminals "a" and "b" of intermit-
tent timer. If continuity is not obtain, replace intermittent timer
and recheck.
7) After intermittent lead wire coupler is connected and intermittent
timer is installed, enable air bag system. Refer to ENABLING
AIR BAG SYSTEM in Section 10B.
Condition Specification
——— Continuity
Continuity
10 – 15 V