Suzuki Wagon R Manual page 1031

10B-34 AIR BAG SYSTEM
DTC 41 – DRIVER PRETENSIONER INITIATOR CIRCUIT RESISTANCE HIGH
DTC 42 – DRIVER PRETENSIONER INITIATOR CIRCUIT RESISTANCE LOW
DTC 43 – DRIVER PRETENSIONER INITIATOR CIRCUIT SHORT TO GROUND
DTC 44 – DRIVER PRETENSIONER INITIATOR CIRCUIT SHORT TO POWER CIRCUIT
DTC 45 – PASSENGER PRETENSIONER INITIATOR CIRCUIT RESISTANCE HIGH
DTC 46 – PASSENGER PRETENSIONER INITIATOR CIRCUIT RESISTANCE LOW
DTC 47 – PASSENGER PRETENSIONER INITIATOR CIRCUIT SHORT TO GROUND
DTC 48 – PASSENGER PRETENSIONER INITIATOR CIRCUIT SHORT TO POWER CIRCUIT
1. From main fuse
2. Ignition switch
3. "AIR BAG" fuse in circuit fuse box
4. SDM
5. Driver seat belt pretensioner
6. Passenger seat belt pretensioner
7. Ground for air bag system
CAUTION:
D When measurement of resistance or voltage is required in this table, use a special digital multimeter
(refer to SPECIAL TOOLS in this section) along with a correct terminal adapter from special tool (Con-
nector test adapter kit).
D When a check for proper connection is required, refer to "Intermittent and Poor Connections" in this
section.
D If there is open circuit in the air bag wire harness, connector or terminal is found damaged, replace
the wire harness, connector and terminal as an assembly.
DTC WILL SET WHEN:
DTC 41 and 45: The resistance of driver or passenger seat belt pretensioner initiator circuit is above a specified
value for specified time.
DTC 42 and 46: The resistance of driver or passenger seat belt pretensioner initiator circuit is below a specified
value for specified time.
DTC 43 and 47: The voltage measured at driver or passenger seat belt pretensioner initiator circuit is below a spe-
cified value for specified time.
DTC 44 and 48: The voltage measured at driver or passenger seat belt pretensioner initiator circuit is above a
specified value for specified time.