Suzuki Wagon R Manual page 1043

10B-46 AIR BAG SYSTEM
ii) Connect connector .
ii) Lock connector with lock lever.
3) Connect Yellow connector of passenger air bag (inflator) module
(if equipped), and be sure to lock connector with lock lever and
close glove box panel.
4) Install "AIR BAG" fuse to circuit fuse box.
5) Turn ignition switch to "ON" and verify that air bag warning lamp
flashes 6 times and then turns off.
If it does not operate as described, perform "Air Bag Diagnostic
System Check" in this section.
HANDLING AND STORAGE
SDM
WARNING:
Never power up air bag system when SDM is not rigidly at-
tached to the vehicle. Otherwise, personal injury may result.
CAUTION:
After detecting one time of such collision as to meet deploy-
ment conditions, the SDM must not be used.
Refer to "Diagnosis" when checking the SDM.
D Never attempt disassembly of SDM.
D When storing SDM (1), select a place where neither high temper-
ature nor high humidity is anticipated and oil, water and dust are
kept off.
D If SDM was dropped from a height of 90 cm (3 ft) or more or if it
is found to be damaged or deformed, replace it with a new one.
D If installation part of SDM was damaged, repair that part com-
pletely before reinstallation.
D All SDM fasteners must be carefully torqued to ensure proper op-
eration of the air bag system.