Quarter Window - Suzuki Wagon R Manual

9-16 BODY SERVICE
12) Check for water leakage by pouring water over windshield
through hose. If leakage is found, dry windshield and fill leaky
point with adhesive. If water still leaks even after that, remove
glass and start installation procedure all over again.
NOTE:
D Do not use high pressure water.
D Do not blow compressed air directly at adhesive applied
part when drying.
D Do not use infrared lamp or like for drying.
CAUTION:
Upon completion of installation, note the following.
D Sudden closing of door before adhesive is completely
set may cause glass to become loose or to come off.
Therefore, if door is opened or closed before adhesive
is completely set, make sure to open all door glasses
and use proper care.
D If molding is not securely in place, hold it down with
a tape until adhesive is completely set.
D Each adhesive has its own setting time.
Be sure to refer to its maker's instruction, check set-
ting time of adhesive to be used and observe precau-
tions to be taken before adhesive is set.
D Refrain from driving till adhesive is completely set so
as to ensure proper and sufficient adhesion.

QUARTER WINDOW

REMOVAL AND INSTALLATION
Refer to "WINDSHIELD" section as removal and installation proce-
dures are basically the same. However, note the following.
NOTE:
Observe the following precautions when applying adhesive (2)
along glass (1) edge.
D Adhesive (2) should be applied evenly especially in height.
D Be careful not to damage primer (3).
D Press glass against body quickly after adhesive (2) is ap-
plied.
Height
Width
Position "d" : 9.5 mm (0.37 in.) for glass lower section.
4. Ceramic print
"a" : 10 mm (0.39 in.)
"b" : 14 mm (0.55 in.)
"c" : 6 mm (0.24 in.)
: 11 mm (0.43 in.) for glass rear section.
: 8.5 mm (0.33 in.) for glass upper section.
"e" : 27.5 mm (1.1 in.) for glass front section.