Suzuki Wagon R Manual page 1048

(1), (2): Release locking of lock lever
(1), (3): After unlocked disconnect connector
1. SDM
2. SDM bolts
3. SDM connector
4. Lock lever
SDM
WARNING:
During service procedures, be very careful when handling
a Sensing and Diagnostic Module (SDM).
Be sure to read "Service Precautions" in this section before
starting to work and observe every precaution during work.
Neglecting them may result in personal injury or inactiva-
tion of the air bag system when necessary.
REMOVAL
1) Disconnect negative cable at battery.
2) Disable air bag system. Refer to "Disabling Air Bag System" ear-
lier in this section.
3) Remove rear console box by removing screws.
4) Disconnect SDM connector from SDM.
CAUTION:
As this connector has a connector lock lever, refer to the
left figure for its removal procedure.
5) Remove SDM from vehicle.
INSPECTION
CAUTION:
D Do not connect a tester whatever type it may be.
D Never repair or disassemble SDM.
D If SDM was dropped from a height of 90 cm (3 ft) or more,
it should be replaced.
D Check SDM for dents, cracks or deformation.
D Check SDM connector for damage, cracks or lock mechanism.
D Check SDM terminal for bent, corrosion or rust.
If any faulty condition is found in above checks, replace.
INSTALLATION
For installation, reverse removal procedure, nothing the following
points.
D Ensure that arrow on the SDM is pointing toward the front of the
vehicle.
D Tighten SDM bolts to specified torque.
Tightening Torque
.
(a): 6 N m (0.6 kg-m, 4.5 lb-ft)
D Connect SDM connector to SDM securely.
D Enable air bag system. Refer to "Enabling Air Bag System" earlier
in this section.
AIR BAG SYSTEM 10B-51